With a switch loop yes, it should. The hot wire should come down from the ceiling on the white wire and go back up on the black wire. Just think ‘white down, black up’. If you wired it the other way around, hot black down and hot white up, you have a problem.
What happens if you reverse the wires on a light switch?
But here’s the catch: If you connect the circuit wires to the wrong terminals on an outlet, the outlet will still work but the polarity will be backward. When this happens, a lamp, for example, will have its bulb socket sleeve energized rather than the little tab inside the socket.
Does it matter where the black and white wires go on a light switch?
The white (neutral) wire connects to the silver screw, or you place it in the back wire hole on the same side of the device as the silver screw. The black (hot) wire goes to the brass screw or into the hole in the back of the device on the same side as the brass screw.
What happens if you wire a 3 way switch wrong?
Usually when a 3-way switch fails, lights can be toggled on and off at one switch, but not the other. If one of the two 3-way switches toggles the light(s) on and off, the other 3-way switch has probably failed. Follow these steps to find which switch is bad. Toggle each switch until the light come on.
Which wire is hot if both are black?
Place the prong of the multimeter’s black wire on the bare metal on the end of a white wire, then read the meter. If you get a reading, the black wire is hot, if you don’t, the black wire isn’t hot.
What happens if you wire a ceiling light wrong?
Tip. The fixture still works if you reverse the wires, but the socket sleeve will be hot, and anyone who touches it while changing a bulb can get a shock. When wired correctly, the socket sleeve is neutral and only the small metal tab at the base of the socket is hot.
Do you switch the white or black wire?
A standard single pole light switch will simply require you to attach the black (load) wire into it, and then the black wire leaving the switch and to your lights. The switch serves to cut the power from reaching the light switch. The white or neutral wire bypasses the switch and goes straight to your lights.
Which wire is hot when both are same color?
In most modern fixtures the neutral wire will be white and the hot wire is red or black. In some types of fixtures, both wires will be the same color. In this case, the neutral wire is always identified by some means.
Can a light switch only have one wire?
Only one cable enters the switch box, coming from the fixture. The white wire to the switch should be marked black to indicate that it is hot. (Ground wires are not shown.) If the line carrying power comes into the light box first, the circuit must still be wired so the switch interrupts the black line.
Why do some light switches have 3 wires?
A 3-way switch makes it easy to turn on a light fixture from two separate locations in the home. Wiring one is slightly different from wiring a single-pole switch. In a standard, single-pole switch, one light switch controls one light fixture—on/off.
What happens if you mix up hot and neutral wires?
This happens when the hot and neutral wires get flipped around at an outlet, or upstream from an outlet. Reversed polarity creates a potential shock hazard, but it’s usually an easy repair. Any $5 electrical tester will alert you to this condition, assuming you have a properly grounded three-prong outlet.
How do I know which wire is hot on a 3-way switch?
The test with the voltmeter. Two of the wires will have house current the one that does not is the