Model. Next cut one end of each line at roughly a 30 degree angle. Turn the bump knob to align the
How do you load a weed eater line?
Apply pressure to wind it evenly. Leave about a foot of the line unwound. To replace an auto feed
How do you change the spool on a craftsman weed wacker?
Press the spool into the hub until it snaps and pull the loose line from the notch. Turn the trimmer over so the tap button on the bottom is facing up. Press the spool into the hub until it snaps and pull the loose line from the notch.
How do you take the head off a Craftsman 25cc weed eater?
So as you just take my screwdriver. And wedge it in right here you want to take your time. And turn
What is the mix ratio for craftsman weed wacker?
40:1 is usually the standard. 50:1 is okay, if the oil manufacturer designed the oil to run at that ratio. Mixing 40:1 oil at 50:1 is a good way to cook your engine. You can run just about ANY oil, so long as you mix it according to the label on the oil bottle.
How do you restring a Craftsman weed eater with two holes?
Same thing put it straight through the middle till it catches. And then all you do is push in and
How do you restring a weed eater with one line?
So that’s about even. So then we go and we start winding. It you wind this one this way. Okay um
How do you rig a weed wacker?
So we’re going to feed the trimmer line through whoops that popped off my holder. As you pull that
How do you remove a weed eater head?
So usually it’s righty tighty lefty loosey in this situation it’s the opposite. So I’m going to
How do you start a weed wacker?
If it doesn’t start however repeat. Step one through six step seven is to wait for it to warm up
How do I mix the gas in my craftsman weed wacker?
All Weed Eater brand two-cycle gas trimmers use a 40:1 ratio of gas to oil. That’s equal to 3.2 ounces of oil to 1 gallon of regular gas. The gas should be 87 octane with no more than 10 percent alcohol.
How do you mix 2 stroke fuel for a weed eater?
Use a 32:1 gasoline to oil ratio. One gallon of gasoline combined with 4 oz of two-cycle engine oil.
How do you use a gas weed wacker?
Never press the trimmer line into the ground or trimming area. Keep making passes until the cut is