- Check the shutoff arm.
- Check the supply valve.
- Inspect the water supply line.
- Test the shutoff switch.
- Check the freezer temperature.
- Inspect the ejector gear.
- Test the ejector motor.
- Test the ice mold heater.
What causes a ice maker to stop working?
Cause: A common cause for a clog is frozen water in the line. … Cause: There is also a possibility that the water filter for the ice maker is clogged. Fix: Locate and replace the water filter. Filters for ice makers are typically located inside the refrigerator (to keep them from freezing).
Where is the reset button on my ice maker?
You can find the reset button at the bottom of the ice maker. Remove the ice tray to locate it. Remove the ice tray. The red button you see is the reset button.
How do I fix my ice maker?
See that wasn’t so bad. But before you go and buy a new ice maker through appliance assistant calm
How do you diagnose an ice maker?
- Check your refrigerator and make sure it’s perfectly level.
- Check your ice maker unit and make sure it’s level.
- Check the water supply line for damage, pinching, or kinks.
- Check the fill cup, make sure it’s aligned correctly with the water funnel.
How do I unclog my ice maker water line?
Drain the line to the ice maker with clean water and reattach. Grab a bucket and put the water line into the bucket and flush it with straight vinegar. This will kill any bacteria that may be hiding in the water line. Flush each of the lines with plain water a few times to clean.
Can a bad filter cause ice maker not to work?
A clogged or incorrectly installed water filter can reduce the water flow to the ice maker and dispenser and could cause one or more of the following: Odd tasting ice or water. Ice maker not producing any ice. Measure fill not working correctly.
How do I force my ice maker to cycle?
- Open the freezer door to remove the ice bin from below the ice maker.
- Empty the ice from the bin. …
- Press the ice maker toggle switch to the “On” setting if it is not already activated.
- Pop off the front cover of the ice maker with the tip of a flat-blade screwdriver.
Why won’t my ice maker fill with water?
Water may not be reaching the ice maker due to a frozen line, missing filter, or a closed supply valve. … When there is no filter, or it is clogged, the ice maker does not get water. Make sure that the filter is in place, and if it has not been changed in more than six months, replace it with a new one.
How do I reset my Kitchenaid ice maker?
Shut the freezer door and allow it to reset for 10 seconds before opening the door. Press the door’s switch three times and shut the door. Let it sit for a few seconds to reset the ice maker. This should stop the blinking lights.
Why is my Kitchenaid ice maker not making ice?
A clogged or incorrectly installed water filter will reduce the water flow to the ice maker and dispenser, which will result in small ice cubes, low ice production or decreased water flow. … A clogged filter will need to be replaced in order to correct the low flow.
Where is the reset button on my Whirlpool ice maker?
- At the bottom of the ice maker.
- Above the ice tray.
- Underneath the ice tray.