If we follow the small line underneath. This one goes in the tank as well it. Goes in the smaller
How do the fuel lines go on a weed eater?
Into the carburetor. Okay. So now the return line does not go all the way down to the gas tank. Okay
How do you replace the fuel line on a Troy Bilt weed eater?
Goes right in here. And it’s in the tank about a half-inch. And in this main line that I replaced
How do you replace the fuel lines on a Ryobi weed eater?
And grab that fuel line if your hemostats. And start pulling and as you pull you will pull the line
Will Weed Eater run without fuel filter?
This reduces the amount of fuel going into the carburetor. The fuel that gets in might be enough to start the weed eater and even keep it idle. But once it’s throttled, the weed eater won t start. You have to clean or replace the fuel filter, before turning it on again.
How do you connect fuel lines?
By using part number two 6-7. 5 for dual feed carbs there are a lot of choices.
How do you put a fuel line in a tank?
Hold the fuel line and push the connector into the fuel line then pull the fuel line out of the top
Why is my weed eater not priming?
Check the Carburetor
The carburetor is located near the choke and primer bulb. … If the fuel lines are intact, the carburetor may just need to be cleaned of buildup. If cleaning doesn’t solve the problem, the carburetor may need to be replaced. It’s cheaper to buy a new carburetor than a new string trimmer.
Where is the fuel filter on a Troy-Bilt weed eater?
The fuel filter is right inside the gas tank.
CONTINUE READING BELOW
Which fuel line goes to the primer bulb?
The (clear) main fuel line with the filter (filter inside the fuel tank) goes to the bottom of the carburetor (or the elbow shaped nipple). The (clear) fuel intake line runs from the top of the carburetor (straight nipple) and goes to the short post on the back of the primer bulb.
How do you replace a fuel line?
Now. When you replace these lines you can get two different types of materials. There’s steel gas