What does ErL mean on my pit boss smoker?

What is ErL on pit boss smoker?

The Pit Boss Er1 (some people call it ErL) code means the temperature probe is not making a connection, and the controller determines it can’t correctly read the probe. It’s likely that your grill’s temperature is too low, or a bad internal thermometer.

How do you fix the ErL code on pit boss smoker?

Alright. Let’s get into errorcode e rh. And that basically means your pit boss smoker is overheating

How do I fix error code on pit boss?

What does Erh mean on my pit boss?

The ERH code is an indication that the unit has overheated possibly due to a grease fire, excess fuel, or the temperature probe wire isn’t properly connected.

Why does my Pit Boss smoker keep going out?

It’s most likely due to the type of pellets you’re using, the age of your grill, ambient temperature, cleanliness, or the hopper design.

Why is my Pit Boss not igniting?

– If your grill is smoking, but not igniting it means there is a lack of airflow from the induction fan. … You should start your Pit Boss Grill on smoke with the lid open for 10 minutes, which will help burn off any additional fuel built up during the startup process.

Where is the fuse on a Pit Boss pellet grill?

Where Is The Fuse on a Pit Boss Pellet Grill? The fuse is located behind the control board on the Pit Boss.

What does P4 mean on a Pit Boss smoker?

The ‘P’ Setting only works when you are using the Pit Boss on the smoke setting, when the grill is operating at the lowest temperature of about 180℉. As soon as you turn the temperature control to the ‘smoke setting’ the default factory P setting is P4.

How do you unclog an auger on Pit Boss?

Use a set of vise grips or a pipe wrench to then turn your auger counterclockwise. And pull it out.

How do you troubleshoot a Pit Boss grill?

Grill Won’t Start:

The most obvious solution to your Pit Boss not heating up is to make sure that your power outlet works and your unit is plugged in. If not, unplug your Pit Boss and re-plug it, making sure that the GFI circuit doesn’t trip. In case it doesn’t reset, you need to check your circuit breakers.

How do you restart Pit Boss?

If you’ve let the grill run completely out of pellets. Because there’s no fuel. Into the auger

Where is the temperature probe on my Pit Boss?

The probe is usually located on the left-hand side of the cook chamber, where the hopper is. Its only purpose is to read the temperature inside the grill and sends the signal back to the control board. The control board then displays the temperature reading on the LED screen, letting you know the grill’s temperature.

What to do if Pit Boss runs out of pellets?

Turn it back to shut down give it a few seconds and then turn it back on to smooth and your trigger